thats cool, where does it load?
sidebar, only drive the NG but they dont let us load anything into RTE 2. something about how the fmc has so little memory it can cause it to reset and accidentally load RTE 2 as RTE 1. kind of annoying as on the bus I was used to programming a special engine out in the secondary and here we just have stupid fix lines and arcs all over the ND
I’ve never seen anyone here do it, and maybe that is why. But I did punch a quick route in (without executing obviously) when we were holding near HNL one night and it wasn’t looking good. Guy i was flying with didn’t seem to have been bothered by it. If it truly can make it crash, and that isn’t just an old -400 wives tale, then it’s probably good nobody uses it. I know it wouldn’t be the weirdest FMS glitch I’ve heard of happening in this hooptie……..cough“dont load the approach in before the descent winds are loaded if going to HI in tails XXX, YYY, and ZZZ, but its cool for all others, but i bet your old CA wont believe that!”cough
Would also be pretty cool if Honeywell or whoever it is, would hook us up with a processor built since i was in middle school. Though my Tandy was pretty great…..
Route 2, or route 1 if you’re already using route 2, works just fine. No glitches. The only issue is when some dimwit sees an execute light if the other route is up and presses the button, not knowing what it is he’s executing, and activates the other route unintentionally.
Either some wives tale or something specific to the NG. Not an issue in the Classic. And not possible in the Jurassic.