All Nippon 737 roll to 131.7 degrees

The narrow-body aircraft continued to roll until it reached 131.7 degrees to the left, leaving it almost belly-up, according to the board. Its nose pointed down as much as 35 degrees at one point.

Man, the EGPWS must have been making one hell of a racket!!!

"BANK ANGLE" "BANK ANGLE"
"BANK ANGLE" "BANK ANGLE"

"HEY MORON!! I SAID BANK ANGLE"
 
The ATR rolled nice in the sim the EMJ not so much. There was a C-17 guy in my new hire class that said a CHS based crew landed missing an engine after they tried to roll it.
 
I have a fuzzy memory of a Desert Storm-era story of a KC-135 crew rolling it, and causing at least one of the engines to come off the wing. Anyone else remember that, or have I just been smoking too much peyote?

Father (former KC-135A pilot) used to tell of a hard-over rudder incident that rolled the aircraft so violently that all four engine pods separated from the aircraft. Don't know where/when that was supposed to have occurred.
 
One of our clown 1900 sim instructors (Colgan) used to do inverted ILS's single engine. Of course this was after he spent a hour or two yelling at you and cursing in the sim.
 
One of our clown 1900 sim instructors (Colgan) used to do inverted ILS's single engine. Of course this was after he spent a hour or two yelling at you and cursing in the sim.

the VASI wouldn't be accurate when he broke out. :)
 
One of our clown 1900 sim instructors (Colgan) used to do inverted ILS's single engine. Of course this was after he spent a hour or two yelling at you and cursing in the sim.

That's not nearly the accomplishment it would be in real life. Hanging from the straps that long would be physically painful.
 
Kansas National Guard 190th ARW.

KC-135missingengines.jpg


You're clear to keep up the peyote. :)

You can read all about it. Apparently the AC wrote a book http://www.amazon.com/exec/obidos/ASIN/1419695029/qw12yu78er34i-20
 
This is always good news for pilots in the eyes of passengers. Now they'll be more satisfied with their flight when we manage not to go belly up on their trip.
 
So...he performed a totally against regs maneuver and caused his own emergency....and then he writes a book about keeping cool under pressure?

That doesn't add up -- maybe we've got something wrong here. The Amazon Preview skipped the pages where he describes the emergency. Anyone have the book?
http://www.190arw.ang.af.mil/shared/media/document/AFD-110331-070.pdf

Looks like it was wake turbulence, not an intentional maneuver. Well thats what they claim anyway.
 
Didn't a B-727 crew do this once? They were manually extending leading edge slats part-way (the "Boeing manuver" I recall), when the engineer failed to pull both breakers simultaneously. One set of slats fully extended causing that wing to stall, rolling the aircraft over and beginning a high speed, spinning descent. The crew was doing everything to recover on the way down including extending landing gear and flaps, and they recovered around 10,000'. They erased the CVR at the gate, and their careers with it.

I don't buy it. Rudder trim? Really? I think he kicked the rudder not the trim.

Tex did a 1G maneuver and did no damage to the aircraft or crew. The same maneuver Hoover does while pouring ice tea inverted.

[YT]Ra_khhzuFlE[/YT]
finally figured out the youtube function....:)
Here the NTSB report on Hoot's problem. View attachment hoot-ntsb.pdf
 
I've had instructors put both the 757 and 767 sims upside down on me during unusual attitude recoveries. The 757 does fine, but the 767 does NOT like being on its back. Lots of dramatics and altitude loss to get it flipped back over. :)

Hope you're not assuming that the real airplane would behave like the sim in this regard. First, it is unlikely an engineering sim, and second, even if it was, I doubt they have any data to support it, so it would be guess work at best. At least one airline learned this lesson the hard way...
 
Back
Top