Grabo172
Well-Known Member
the average jet has the same number of sectionals on board as the average glider has transponders on board.
Zing!:rotfl:
the average jet has the same number of sectionals on board as the average glider has transponders on board.
The biggest problem I see is battery + transponder + mode c encoder = more weight and MONEY.
the average jet has the same number of sectionals on board as the average glider has transponders on board.
Regarding the battery problem, it would be interesting if it could remain charged with a small solar panel (the dashboard battery trickle-charge type) or ram air turbine. The most cost effective solution would probably be to just remove the battery and charge it between flights.
The biggest problem I see is battery + transponder + mode c encoder = more weight and MONEY.
Edit: I'm voting yes, because I think if a smaller combination transponder/mode c encoder unit were offered specifically for the glider market it wouldn't be as big of a deal.
I should have said that it was near Class B airspace, DFW.
Most of us don't. The majority of modern gliders are made of fiberglass (non-radar reflective) and carbon fiber. Those of us who operate in busy airspace are generally aware of where most fast ifr traffic is coming from and going to. The only glider / jet mid-air in SoCal that I'm aware of was at 500'agl on a ridge when a Navy A-4 lopped of the last meter of a glider's wing. According to the story the A-4 pilot wasn't even aware of what happened until his crew chief asked about the fiberglass shards in the wing :cwm27:. The glider landed safely back at the airport. This happened in a non-radar coverage area, a transponder wouldn't have helped.I'm sure many glider pilots operate under the assumption that ATC will see a primary return on them...
Your lack of a sectional chart on your jet doesn't relieve you of your legal requirement to familiarize yourself with all available information concerning your flight. That information is available in other publications that you should have in your possession. Passing at VFR altitudes through an area known to have a high concentration of gliders without at least giving it a thought constitutes a failure to properly plan your flight.
Let's steer this back in the direction of the original question...
Most of us don't. The majority of modern gliders are made of fiberglass (non-radar reflective) and carbon fiber. Those of us who operate in busy airspace are generally aware of where most fast ifr traffic is coming from and going to. The only glider / jet mid-air in SoCal that I'm aware of was at 500'agl on a ridge when a Navy A-4 lopped of the last meter of a glider's wing. According to the story the A-4 pilot wasn't even aware of what happened until his crew chief asked about the fiberglass shards in the wing :cwm27:. The glider landed safely back at the airport. This happened in a non-radar coverage area, a transponder wouldn't have helped.
Two years ago a Hawker hit a glider at 16,000 feet near Reno. Glider pilot parachuted down. Hawker landed with severe damage. Transponder was OFF to save power. That has 91.13 written all over it.The only glider / jet mid-air in SoCal that I'm aware of was at 500'agl on a ridge when a Navy A-4 lopped of the last meter of a glider's wing.
You may want to rethink that "historical data" idea. Historical data contains NOTHING on the numbers saved because of TCAS. I can't tell you how many times/week we get TAs and RAs. Many of which are within radar control.There are always going to be isolated incidents of near-midair collisions with gliders but how many near-midairs have occurred where both aircraft were equipped with Mode C? Take a gander at the historical data.
You may want to take a look at all of the STARS west coast airports. They ALL bring arriving jets over the mountains in the low Teens. Just because you are not near a Class B/C, does not mean that it isn't controlled. I don't care where the thermals are, the jets/IFR traffic are on published arrivals...stay out of them.... the vast majority of glider operation takes place in uncontrolled airspace over sparsely populated areas.
Too Bad. That is like a bungee jumper complaining the rope is too heavy or interferes with the fall.Adding things like transponders, batteries, wind generators, etc. greatly increases weight and drag, both mortal enemies of the glider.
CORRECTION: It was 2006.Two years ago a Hawker hit a glider at 16,000 feet near Reno.
Two years ago a Hawker hit a glider at 16,000 feet near Reno. Glider pilot parachuted down. Hawker landed with severe damage. Transponder was OFF to save power. That has 91.13 written all over it.
Most of us don't. The majority of modern gliders are made of fiberglass (non-radar reflective) and carbon fiber.
You may want to take a look at all of the STARS west coast airports. They ALL bring arriving jets over the mountains in the low Teens. Just because you are not near a Class B/C, does not mean that it isn't controlled. I don't care where the thermals are, the jets/IFR traffic are on published arrivals...stay out of them.
Well, the glider (or any other aircraft for that matter) has just as much right to be there as you do in VMC. TCAS or TIS are not a substitute for a visual scan, and just because you are IFR does not change the fact that you are ultimately responsible for visually avoiding traffic.
Sorry, that argument holds as much water as a screen door in a submarine. No, TCAS isn't a substitute, but it is the BEST we have. Even if you know where a glider is to look, you probably won't see it in time to avoid it at normal jet speeds. There is no such thing as a "Right" to play on an airway, any more than there is a "right" to jump rope on an Interstate, then get mad because someone hit you. Maybe if you had flown 350 kts in hazy mountains you might know how hard it is to "visually avoid." Easier said than done. So if you want to guarantee you won't get run over, turn on your xponder. Then, we can see you farther out than visual range and make an adjustment.Well, the glider (or any other aircraft for that matter) has just as much right to be there as you do in VMC. TCAS or TIS are not a substitute for a visual scan, and just because you are IFR does not change the fact that you are ultimately responsible for visually avoiding traffic.