You were a smarter pilot than I, every near death experience I had was purely me being dumb.The closest I ever came to dying in an airplane was due to asymmetric flaps.
Assuming they can't be corrected (raised), do you just crab and slip? No training on that thus far in my life.The closest I ever came to dying in an airplane was due to asymmetric flaps.
Probably depends heavily on your specific airframe.Do you just crab and slip? No training on that thus far in my life.
At this point in my life it'd be a 172 most likely. I do no flaps almost as much as I do normal landings so that it's a non-event if they get stuck. In X-plane I tried asymmetrical 172 flaps but the plane isn't controllable.Probably depends heavily on your specific airframe.
I’d have to think through it but in a 172 first thing I’d probably try after getting the thing under control is to retract the flaps to get them both up or at least more symmetrical. Many other aircraft I wouldn’t as you could make things worse, but the Cessna cross cable setup the worst that would happen is the motor stalls out and trips the breaker and you’re still stuck with the asymmetry.At this point in my life it'd be a 172 most likely. I do no flaps almost as much as I do normal landing so that it's a non-event if they get stuck, in X-plane I tried asymmetrical but the plane isn't controllable.
Yes, but i'm just wondering in the event that you can't retract the flaps and have to land in an asymmetrical position. If that's even possible as it seems near impossible in X-plane if they're stuck at 30 degrees on one side and up on the other in a 172.I’d have to think through it but in a 172 first thing I’d probably try after getting the thing under control is to retract the flaps to get them both up or at least more symmetrical. Many other aircraft I wouldn’t as you could make things worse, but the Cessna cross cable setup the worst that would happen is the motor stalls out and trips the breaker and you’re still stuck with the asymmetry.
Well, I think you’d put in full aileron, and if that doesn’t stop the roll, add a bootful of rudder too and accept whatever slip/skid that gives you. I would also be careful with speed changes if you have it under control-though on a 172 I think faster would be better? Because you have 2 ailerons and a rudder working against the single flap that’s trying to roll you and the faster you go the more effective they would be?Yes, but i'm just wondering in the event that you can't retract the flaps and have to land in an asymmetrical position. If that's even possible as it seems near impossible in X-plane if they're stuck at 30 degrees on one side and up on the other in a 172.
This is all why a club's maintenance is so important to me. After twice finding tools inside aircraft rolling around when I lifted the elevator and shook the wings respectively during preflight, I left a club years ago wondering what else their mechanics must be doing carelessly.