The importance of doing a good flight control check!

Yep, tried it. The FO and I laughed.
One of the many reasons I'm not necessarily a fan of the single engine taxi, especially on departure, unless it's an absolute necessity. Just one more stress taxiing around a busy place and I've seen captains get stuck in a rut or on a slope enough times that you wonder if having to blast the one engine up to 50% to get the thing rolling is really saving any gas.
 
One of the many reasons I'm not necessarily a fan of the single engine taxi, especially on departure, unless it's an absolute necessity. Just one more stress taxiing around a busy place and I've seen captains get stuck in a rut or on a slope enough times that you wonder if having to blast the one engine up to 50% to get the thing rolling is really saving any gas.
When I was a captain at your shop I hardly SE-taxied in the way out. Pretty much only did it if I thought the taxi would be greater than 25 min.

On the way in, when conditions permitted, it was 3 minutes and stop #1.
 
When I was a captain at your shop I hardly SE-taxied in the way out. Pretty much only did it if I thought the taxi would be greater than 25 min.

On the way in, when conditions permitted, it was 3 minutes and stop #1.
I did this the other day... Marshaller stopped me short.

"Ah.... crap..."
 
  • Like
Reactions: bp
I had never heard the Lufthansa A320 or USAF F-15 stories until this thread, thank you for the info. This is why when a plane at my flying club comes out of heavy mx, it's usually a few days until someone decides to be the first to fly it. Not flight control related per se, but my primary CFI was ferrying a 172 after it's annual on the 10nm flight from PAO to SQL and when he pulled the throttle out on approach, it came out in his hand! The engine was still running at a high enough RPM to get into slow flight, land, and even exit the runway to stop on a taxiway near the flight school. That could have been very bad had a solo student or new PPL ended up in that situation, he was a very experienced career CFI and just laughed about it.

@MikeD, perhaps you should consider one of your JC reports for this incident, it sounds very interesting.
 
I had never heard the Lufthansa A320 or USAF F-15 stories until this thread, thank you for the info. This is why when a plane at my flying club comes out of heavy mx, it's usually a few days until someone decides to be the first to fly it. Not flight control related per se, but my primary CFI was ferrying a 172 after it's annual on the 10nm flight from PAO to SQL and when he pulled the throttle out on approach, it came out in his hand! The engine was still running at a high enough RPM to get into slow flight, land, and even exit the runway to stop on a taxiway near the flight school. That could have been very bad had a solo student or new PPL ended up in that situation, he was a very experienced career CFI and just laughed about it.

@MikeD, perhaps you should consider one of your JC reports for this incident, it sounds very interesting.

I'll have to revive that series here. Get a new stack of accidents to do a report on. Of course, speaking of gust locks, one report I did covers just that below....... Thanks for remembering those.

Yup...personally my hand doesn't come off of it until it's fully released once I flip the switch. Too easy to end up like the Eagle crew in Norfolk otherwise...

Or end up like this C-54 crew in FFZ:

When a Long Roll Leads to a Short Demise
 
Yup...personally my hand doesn't come off of it until it's fully released once I flip the switch. Too easy to end up like the Eagle crew in Norfolk otherwise...

Is
Yup...personally my hand doesn't come off of it until it's fully released once I flip the switch. Too easy to end up like the Eagle crew in Norfolk otherwise...

I tried searching for but couldn’t find anything. Is there an article on this incident?
 
I had never heard the Lufthansa A320 or USAF F-15 stories until this thread, thank you for the info. This is why when a plane at my flying club comes out of heavy mx, it's usually a few days until someone decides to be the first to fly it. Not flight control related per se, but my primary CFI was ferrying a 172 after it's annual on the 10nm flight from PAO to SQL and when he pulled the throttle out on approach, it came out in his hand! The engine was still running at a high enough RPM to get into slow flight, land, and even exit the runway to stop on a taxiway near the flight school. That could have been very bad had a solo student or new PPL ended up in that situation, he was a very experienced career CFI and just laughed about it.

@MikeD, perhaps you should consider one of your JC reports for this incident, it sounds very interesting.
I had a similar thing happen in a Warrior. Throttle went up then didn't come back. Luckily it was easy to get down with the mixture.
 
Back
Top