Right rudder

.

The TBM-700 has a yearning to roll and yaw when you make a power lever change, which means if you cob the power at low speed, you might have some "fun" once things start catching up.

The TBM-3 too.

Here's one just a teensy bit bigger...
When you jump into one of these to launch for the first time, just trim full rudder, then push the pedal to the floor, add power and hold on...

Was a big challenge for the VNAF with its new pilots.
 
The Caravan has a rudder trim setting for take off. Very helpful with the Caravans on floats. Some use the water rudders to get established then raise them on the take off run. I always tried not to lower them during the take off run, if you forget them, they will depart the airplane. It isn
 
Is that because of something unique to the Saab? On the jet I flew, the captain would usually transfer the controls on the roll if it was a rolling takeoff or once lined up.

@z987k

The only way to steer the Saab on the ground is through the tiller. Thus, on legs where the FO is the PF, the CA retains directional control until the rudder becomes effective enough for the FO to have good control with the rudder.
 
I am not sure how other companies do it, so I dont know if it is a SAAB thing or company thing. @ctab5060X @jynxyjoe

Setting the power is la three step process. The Captain sets the torque 15-20% below the desired torque setting. Once the power lever is pushed past the 64 degree switch I make sure the autocoarsen goes high. Once the torque is in the proper setting I engage the APR, making sure to announce the APR is armed. Then announce the power is at whatever setting I have dialed in the CTOT box. The power is fully set about 70-80 knots.
Sounds right to me.

Make sure, at least once, you leave that ctot switch on, but dialed all the way down to 86 or whatever it is and watch as the other guy pulls power back below the 64 switch. Oh the faces they will make. Ive done it on accident, felt like a complete moron, but makes ya humble.
 
The Q400 has a yaw damper, but since it has very limited authority over the rudder (IIRC, something like 3 degrees of travel), it's completely overpowered by any kind of power change.

Since DHC made a ton of compromises in keeping the common type rating for the entire Dash-8 family (and keeping the airplane cheap), I wouldn't be at all surprised if they just borrowed the yaw damper from the smaller (and less powerful)
models and slapped it into the Q400.

The YD is worthless on the 200 and 300 too. Although with the YD MEL'd it's the vomit express in the back.

Always always always have to trim after power changes. Or you can just sit sliding off your seat to one side or the other.
 
I fly the small Diamond 40 which requires a good amount of right rudder at the appropriate times. I can only assume this to be true with the other small single engine trainers.

However, I started thinking about the bigger single engine airplanes that I get to see here and there.

What about the Pilatus's and the Caravan's and the TBM's. Do they also require a significant amount of the rudder on the takeoff roll and the like?

It could be a stupid question but I've yet to fly in a bigger single engine.
Yep. Anything with a clockwise turning propeller, including any multiengine aircraft that do not have counter-rotating engines. As mentioned above, some larger aircraft have systems to mitigate the left turning tendencies. Often when we're training new hires to fly the Dash 8 200/300, I have to train people to use their right foot again.
 
If you watch videos of big piston fighters taking off, you can hear the pilots make two different power applications on the takeoff roll. They'll initially apply enough power to get rolling, get airflow over the rudder, and get the tail airborne, and then once there's more flight control authority they'll go to full takeoff manifold pressure.

I've always found that the tailwheel lock made things a little easier as well.
 
Sounds right to me.

Make sure, at least once, you leave that ctot switch on, but dialed all the way down to 86 or whatever it is and watch as the other guy pulls power back below the 64 switch. Oh the faces they will make. Ive done it on accident, felt like a complete moron, but makes ya humble.
Hahaha. One time we were empty and reduced. It was such a low setting we barely could get the power levers past the 64 degree switch.
 
ASpilot2be said:
I am not sure how other companies do it, so I dont know if it is a SAAB thing or company thing. @ctab5060X @jynxyjoe Setting the power is la three step process. The Captain sets the torque 15-20% below the desired torque setting. Once the power lever is pushed past the 64 degree switch I make sure the autocoarsen goes high. Once the torque is in the proper setting I engage the APR, making sure to announce the APR is armed. Then announce the power is at whatever setting I have dialed in the CTOT box. The power is fully set about 70-80 knots.
That's how we did it on the Saab also. The 1900 whoever was flying did everything since you had steering with the rudder pedals. I've only flown right seat in the sim on the Challenger, but since we have 7 degrees of steering with the pedals, you just did everything from that seat.
 
That's how we did it on the Saab also. The 1900 whoever was flying did everything since you had steering with the rudder pedals. I've only flown right seat in the sim on the Challenger, but since we have 7 degrees of steering with the pedals, you just did everything from that seat.
The last time I touched power levers on takeoff was during sim. Kind of an odd feeling.
 
I fly the small Diamond 40 which requires a good amount of right rudder at the appropriate times. I can only assume this to be true with the other small single engine trainers.

However, I started thinking about the bigger single engine airplanes that I get to see here and there.

What about the Pilatus's and the Caravan's and the TBM's. Do they also require a significant amount of the rudder on the takeoff roll and the like?

It could be a stupid question but I've yet to fly in a bigger single engine.

Not sure. Just hit the yaw damper. Lol. Jk. I do fly a 208. Initially on takeoff yes it does take some extra. Trim it out they engage the YD
 
Back
Top