Old pilot, bold pilots, no old bold pilots

This is some crazy DZ flying! Watch the cockpit video first then the ground view.

Embedded media from this media site is no longer available




 
I see great handling and mastery of ones aircraft and limitations. I however also see something that is very unnecessary and probably something that will one day bite him in the ass.
 
I admit I hit Vne 3 times in a King Air 90 when dropping. Each of those times was unintentional since I was only trying to maintain yellow arc, but I hit the high end due to scanning outside for my jumpers and traffic. On smooth days I had no problem staying in the yellow arc at -3,000 to -7,000 fpm to the ground. If you know the aircraft limitations and where traffic and jumpers are it can be done safely.

Most days would not allow it though due to turbulence, traffic or other external factors and the descent needed to be at the top of the green arc.

This is a DZ pilot's daily grind :)
 
I see great handling and mastery of ones aircraft and limitations. I however also see something that is very unnecessary and probably something that will one day bite him in the ass.
Have you flown at a DZ before?

This is pretty much SOP at all turbine dropzones. You are expected to get maximum productivity out of the airplane by doing as many loads as quickly as safety permits. The flight path of the jumpers and airplanes are well planned to avoid conflict. Most large DZs like the one shown here have full time professional pilots. This is NOT the place for a low time pilot trying to build hours.
 
Have you flown at a DZ before?

This is pretty much SOP at all turbine dropzones. You are expected to get maximum productivity out of the airplane by doing as many loads as quickly as safety permits. The flight path of the jumpers and airplanes are well planned to avoid conflict. Most large DZs like the one shown here have full time professional pilots. This is NOT the place for a low time pilot trying to build hours.

I have not but I have friends that do and have spent time at a few of the DZ's watching the action. I understand the need to get down quickly (time = $). However, not a single DZ I've ever been to did I see an airplane knife-edging it at 20 ft agl.

Edit to add: Not claiming to be at all an expert concerning DZ operations. In this my first response I was just calling it like I saw it. From a safety viewpoint, seems risky and unnecessary.
 
However, not a single DZ I've ever been to did I see an airplane knife-edging it at 20 ft agl.

Edit to add: Not claiming to be at all an expert concerning DZ operations. In this my first response I was just calling it like I saw it. From a safety viewpoint, seems risky and unnecessary.

Yes, the low alt turn did seem excessive to me but I don't know any of the specifics about that airplane, airport, or operation so I will not jump to any conclusions based on a youtube video.

When I was flying jumpers the profile was,

Vne down to crossing midfield at 100-200 AGL, pull up to bleed off the energy while turning onto downwind, and make a normal power off landing.

This was at a DZ with it's own grass strip, so there wasn't much other traffic to worry about.
 
Cool maneuver but that guy might kill himself or someone else some day. flying downwind, base, final at that altitude leaves very little margin for safety. In my 12 short years of aviating, I've come to feel that having a good margin (be that altitude, fuel or whatever) for f-ups and unforeseeable variables can save you some regret.

That said, it looked very cool.
 
It all comes down to the question of if "unnecessary" = "unsafe."

Lots of unnecessary shenanigans, for sure. None that make me think, "OMG! Pull his license!" though.

This type of stuff is par for the course at a lot of DZs. They generally maintain very high safety records, oftentimes to my amazement.
 
Back
Top