crazynut52
New Member
I heard they are bore scoping all the engines in the field. Does anyone know the reasons for any of these failures?
Where did you "hear" that?I heard they are bore scoping all the engines in the field. Does anyone know the reasons for any of these failures?
Who, What, When, WhereI believe him I'm just wondering if there is anything official out there. I was talking to one of our guys that had an engine failure in the van just a couple days ago.
English eludes me. It was the one down in BHM a while back. I talked to him this week.Who, What, When, WhereI didn't hear anything about this. I'm kinda in the booneys...
Oh I thought you meant the engine failure happened last week not talking to him. Yeah, I talked to him about it too awhile ago. Fun stuff!English eludes me. It was the one down in BHM a while back. I talked to him this week.
If the Trend montoring shows it wasn't out of operational limits then it probably isn't the operators fault. I'm not sure exactly how often the trend monitor records, but I beleive it's every start and then a set interval after that. Unless you over temp it between the trend monitor, the hot section most likely will not crack under normal ops. Especially if there is a whole host of hot sections popping up in the -114 series.I saw a hot section from a Caravan a week ago that had just been replaced, it had cracks in several of the blades. It was on a trend monitoring system. I'm not sure how effective this system is but, I'm thinking some failures could be caused by operator mishandling the rather than manufacturing defects.
If the Trend montoring shows it wasn't out of operational limits then it probably isn't the operators fault. I'm not sure exactly how often the trend monitor records, but I beleive it's every start and then a set interval after that. Unless you over temp it between the trend monitor, the hot section most likely will not crack under normal ops. Especially if there is a whole host of hot sections popping up in the -114 series.